How To Clear Config On Cisco Switch Port

Cisco IOS – Return an Interface to Default (Remove all Settings)

KB ID 0001010

Problem

The configuration for a particular interface can get quite long, you could go to interface configuration mode, and prefix all the commands with a 'no'. But this can be a bit repetitive and time consuming.

cisco switches

Solution

To remove the configuration for interfaces use the 'default' command. for example take a look at the following config for FastEthernet1/0/5.

Petes-Switch>enable              Petes-Switch#show run              Building configuration...  Current configuration : 1854 bytes !              <----------config removed for brevity---------->              ! interface FastEthernet1/0/5 switchport access vlan 999 switchport mode access !              <----------config removed for brevity---------->              ! end

To remove the configuration for that port, use the following command.

Petes-Switch#configure terminal              Enter configuration commands, one per line. End with CNTL/Z. Petes-Switch(config)#                default interface FastEthernet 1/0/5                            Interface FastEthernet1/0/5 set to default configuration Petes-Switch(config)#

To check it worked.

Petes-Switch#show run              Building configuration...  Current configuration : 1854 bytes !              <----------config removed for brevity---------->              ! ! interface FastEthernet1/0/5 !              <----------config removed for brevity---------->              ! end

Reset / Remove the Configuration for Multiple Ports

You can combine selecting multiple Cisco device ports with the default command, to remove the configuration, and reset a 'range' of ports in one command.

Petes-Switch(config)#default interface range GigabitEthernet 0/3 - 6

How to Remove the Configuration for a Cisco ASA 5500 Port

To do the same on a Cisco ASA you need a different command, you use the 'clear configure' command. Note: The interface naming used here is for an ASA8885-X the interfaces on your model may have a different naming standard, i.e. vlan1, ethernet1 etc.)

Petes-ASA(config)#clear configure interface GigabitEthernet0/1